Expert Answers about Car Audio

• How Does Furrion Sound Bar # FSB24SA2C-BL Wire to RV Stereo
• The Furrion RV Soundbar # FSB24SA2C-BL is a passive speaker that requires powered speaker wire ran to it just like any standard car audio speaker. The Jensen stereo you mentioned having would speaker out wires that are amplified that you'd need to use speaker wire to connect to the # FSB24SA2C-BL.
  view full answer...


• Are There Custom Install Wiring Harnesses for Jensen Mechless RV Stereo JHD1130WP
• We do not have custom stereo install harnesses for our stereos like the Jensen Mechless part # JHD1130WP that you referenced. Your best option will be to use the included wiring diagram to wire to the labeled wires of your vehicle's stereo wiring. If that seems like a bigger job than you'd be interested a local car audio installer should have no problem.
  view full answer...


• Replacement Option for iRV RV Stereo iRV33
• The Drive RV Stereo part # 324-000031 has one zone with a max output of four speakers. Therefore, this would not be a good replacement for an iRV RV Stereo part iRV33. Furthermore, you would actually need a double din not a single din like the above. I recommend the Furrion RV Stereo part # DV1230BL as this has three zones, double din mounting, and work with up to a total of six speakers. It also has HDMI ports and in my experience is better quality than the iRV options. Unfortunately,...
  view full answer...


• Is a Wire Needed Between the Alternator and Redarc In-Vehicle BCDC Battery Charger
• Yes, you will have to run a power wire from the alternator to the Redarc In-Vehicle BCDC Battery Charger part # 331-BCDC1225D which gets installed on the trailer, there is no way around this nor would there be for any other battery charger of its kind. The correct size of wire to use will have much to do with the length between the alternator and trailer battery. Most likely you will need a 6-8 AWG wire. If you have any local car audio stores nearby they will most likely be able to sell...
  view full answer...


• Redarc Charger for 2018 Chevy Colorado ZR2 with Dual Battery Setup
• The Redarc In-Vehicle BCDC Battery Charger # 331-BCDC1240D that you referenced is the correct charger setup you'd need. It can put out up to 40 amps and is compatible with smart alternators like you have as well. I attached an install diagram that shows how it will wire up (without the solar panel you see pictured) as well as a link to the install instructions as well.
  view full answer...


• Tip for Solving Connection Issue Using Furrion Observation System with 2017 Mercedes GLE 400
• I really appreciate all the homework you did on this and i believe I have an easy solution that will allow you to draw power for the camera from the battery but still use the running light circuit. For that you'd want the Tow Ready Isolation Solenoid part # PK5231201. You'd connect the two side pins to the battery and the camera and then the center pin goes to the running light circuit. The varying voltage will still allow the solenoid to be active so that will not longer be an issue.
  view full answer...